Namz Throttle-By-Wire Twist Grip Position SensorNamz Twist Grip Sensor for TBW
Hardwired like OEM CVO versions from the sensor to the main connection on the harness, same length as OEM
Terminals are pre-installed using MIL-SPEC crimping presses
Includes OEM-type connector for installation after the harness is routed through the handlebar
Includes installed OEM 2-position heated grip connection
Works with stock handlebars
Made in the USA
Hardwired like OEM CVO versions from the sensor to the main connection on the harness, same length as OEM
Terminals are pre-installed using MIL-SPEC crimping presses
Includes OEM #69201162 micro-connector for installation after the harness is routed through the handlebar
Includes installed OEM #72902-01BK 2-position heated grip connection
Works with stock handlebars
Product Note:
Specification
Details
Country of Origin
USA
OEM Reference
Varies (make selection above)
Country of Origin
USA
OEM Reference
32700050A
Vehicle Fitment
Fitment is guaranteed or your money back plus free return shipping.
Don’t waste time installing a product that doesn't fit. We worked hard ensuring that this product is an exact fit on the vehicles listed below.
Yes, these twist grip sensors plug straight into the OEM wire harness and will work with the stock cruise control system on any machine that comes from the factory equipped as such.
if it comes de pinned, how do you know what slots to put the wires in does anybody have a diagram?
By Howard F.
These twist grip sensors come with instructions that indicate exactly where to put the pins upon installation. It makes replacing the OEM Harley-Davidson twist grip sensor really easy and there are no special tools required.
will it work with heated grips? will it pull easy thru the bars? will it come depinned? also is it long enough for 10 inch bars?
By kevin
All Namz twist grip position sensor kits come with a OEM-type 2-wire heated grip connector, so you're all set there. The larger throttle sensor connector is not connected to the harness, de-pinned, as you say - so it makes pulling the harness through the handlebars pretty easy. The heated grip connector is assembled, but it's small enough to make pulling it through a non-issue.
Whether or not it's long enough for your particular handlebars is difficult to say without knowing what machine it is that you have, what handlebars you're using &etc. I can tell you that the harness is the same length as stock, so if you need more cable, you can find that on our Namz Plug-N-Play Handlebar Wiring Extension Kit page. With those two kits, you'll have everything you need to install your bars.
Verified Purchaser
