Twin Power Ignition Wires

V-Twin motorcycles are the heart and soul of America's motorcycle industry. There's no better way of showing the pride you put into your motorcycle than by using American made parts.

• Twin Power ignition leads are 8.65mm thick with 500-Ohm/ft. of resistance
• The core of these leads are made with aramid fiber reinforced by fiberglass strands for additional strength
• Only mag wire is used to ensure conductivity and elimination of RFI (radio frequency interference) and noise suppression
• The core is then covered by a layer of EPDM with a layer of braided tape for strength and flexibility
• The outer jacket protecting the mag wire core is a high quality silicone to ensure heat resistance is maximized, extending the longevity of the wire set
• Silicone distributor and spark plug boots are used to help dissipate the heat
• Stainless steel terminals are used to reduce potential corrosion
• Each ignition lead is built with SAE J2031 class E rated cable for heat protection of 4500 degrees Fahrenheit
• Each wire set includes a packet of dielectric grease to prevent arcing, keep moisture out, and prevent corrosion
• Each wire set includes two miniature cable ties
• Made in USA