Cobra headpipe merges into a large 2-1/4 inch collector that steps up to a 2-1/2 inch core
Perforated core is wrapped it in a stainless steel screen then enclosed in fiberglass pillow for sound and performance
Large one-piece heat shield over collector is held in place with two clamps
Stamped the Cobra logo on it as well
4-inch muffler body capped with machined aluminum dual-cut tip with alluvial flutes
Muffler body can be rotated 10-degrees up or down from its center position allowing the rider to determine the final position
Exhaust works with either stock or extended bags
Comes with all required installation hardware and easy-to-follow instructions
Made in the USA
Product Note:
Specification
Details
CARB Approved
No
Color
Varies (make selection above)
Configuration
2-into-1
Country of Origin
USA
Engine Type
Varies (make selection above)
Finish
Varies (make selection above)
Muffler End Cap
Black Aluminum
Warranty
Varies (make selection above)
Vehicle Fitment
Fitment is guaranteed or your money back plus free return shipping.
Don’t waste time installing a product that doesn't fit. We worked hard ensuring that this product is an exact fit on the vehicles listed below.
Sounds good easy install, happy. Had dual cobra neighbor haters also liked.
Great Look
By E. on
These pipes scream quality and look really good. Sound is of good depth however will crackle when dropping rpms. Clean crisp look.
Love the pipes
By Joseph D. on
Verified Purchaser
Read the fine print, if you have saddlebag guards on your roadglide, you're going to have to modify the bracket and that is very much against the manufacturers recommendations.
Having said that, love the pipes. Nice tone, not obnoxious but definitely growl to them. Love the look also.
Cobra Turnouts
By Edward K. on
Verified Purchaser
Amazing product
How many stars would you give this product? Write a review.
Verified Purchaser
