570 cams are bolt-in cams. Cams that exceed the limits of the stock valve springs require the use of special high lift springs. Most S&S cams have higher lift than stock and are designed to take advantage of the extra flow of ported stock heads or S&S Super Stock heads. Due to the high lift of these cams, S&S adjustable pushrods are recommended. Not all grinds are available in the chain drive version. To get the best performance from a performance cam installation, a high flow intake and exhaust system is also recommended.
Designed for 88 to 96 CID engines with compression ratios between 9:1 and 10:1 this cam will provide a nice power increase across the entire power band. 3200-5700 rpm.
Quick installation and Easy Start Cams allow stock starter to start any engine.
Kit contains cams, gear cover gasket, cam bearings, and instructions.
Product Note:
Specification
Details
Country of Origin
USA
Drive Type
Varies (make selection above)
Exhaust Duration
255 degrees
Exhaust Lift
.179 in.
Exhaust Lobe Center
107.5 degrees
Exhaust Timing (Close)
20 degrees
Exhaust Timing (Open)
55 degrees
Intake Duration
240 degrees
Intake Lift
.187 in.
Intake Lobe Center
100 degrees
Intake Timing (Close)
40 degrees
Intake Timing (Open)
20 degrees
Valve Lift
.570 in.
Vehicle Fitment
Fitment is guaranteed or your money back plus free return shipping.
Don’t waste time installing a product that doesn't fit. We worked hard ensuring that this product is an exact fit on the vehicles listed below.
