585 cams are bolt-in cams. Cams that exceed the limits of the stock valve springs require the use of special high lift springs. Most S&S cams have higher lift than stock and are designed to take advantage of the extra flow of ported stock heads or S&S Super Stock heads. Due to the high lift of these cams, S&S adjustable pushrods are recommended. Not all grinds are available in the chain drive version. To get the best performance from a performance cam installation, a high flow intake and exhaust system is also recommended.
Designed for 88 to 96 CID engines with compression ratios from 9:1 to 10:1 and 100 to 111 CID engines from 9.7:1 to 10.5:1 compression. Provides massive horsepower and torque increases starting at 3000 rpm and holds steady all the way to redline. 3500-6000 rpm for 88"-96" engines and 2500-5500 for larger engines.
Quick installation and Easy Start Cams allow stock starter to start any engine.
Kit contains cams, gear cover gasket, cam bearings, and instructions.
Product Note:
Specification
Details
Country of Origin
USA
Drive Type
Chain Drive
Engine Type
Varies (make selection above)
Exhaust Duration
260 degrees
Exhaust Lift
.179 in.
Exhaust Lobe Center
110 degrees
Exhaust Timing (Close)
20 degrees
Exhaust Timing (Open)
60 degrees
Intake Duration
245 degrees
Intake Lift
.186 in.
Intake Lobe Center
102.5 degrees
Intake Timing (Close)
45 degrees
Intake Timing (Open)
20 degrees
Valve Lift
.585 in.
Vehicle Fitment
Fitment is guaranteed or your money back plus free return shipping.
Don’t waste time installing a product that doesn't fit. We worked hard ensuring that this product is an exact fit on the vehicles listed below.
Can I use these cams on my stock 07 dyna super glide custom? 96 ci
By Dustin K.
Yes, if you were to choose the 2007 Harley Davidson FXDC Dyna Super Glide Custom cams from our fit guide, you'd receive the correct parts to fit your machine. Mind you, as noted in the description, these cams do require S&S high lift valve spring kit 106-5909.
With those two kits, you should be all set!
Will the valve springs need to be changed with these on a 14 flhx 103"?
By Anon.
Yes, we certainly do recommend the installation of high-performance valve springs for all Twin Cam engines when valve lift exceeds .551 inches. The heavier valve springs will prevent valve float and, in doing so, insure your engine runs properly on the bigger cams.
Verified Purchaser
